Onboarding 60 GHz E2E Controller

There are two ways to deploy 60 GHz E2E Controller:

External E2E Controller
Onboard E2E Controller

External E2E Controller Onboarding

To Onboard the External E2E Network through Monitor and Manage page:

1. Navigate to Monitor and Manage > Network > select 60 GHz cnWave E2E Controller.
2. Click Approve and 60 GHz cnWave–Network Onboard window appears.

3. By default, Auto-assign is selected you can select Auto-assign or Manual to update IPv6 address in E2E Network and wait for a while until IPv6 address gets updated.
4. Enable Layer 2 Bridge if required.

5. Click Apply.
6. Wait for a while till network onboard is successful.

7. After successfully onboarded, the External E2E Network UI shows the Dashboard of the network as shown below:

External E2E Controller network icon will be indicated with icon as shown below:

Onboard E2E Controller (Running Onboard)

cnMaestro remote management details are configured through onboard E2E controller. The Onboard E2E Controller is hosted on a 60Hz cnWave device. (E2E Controller option to be enabled in the device UI).

To approve proceed as follows:

1. Navigate to Monitor and Manage > Network > select 60 GHz cnWave E2E Network.
2. Click Approve.

60 GHz cnWave-Network Onboard window appears. Edit network name and click Save.

3. Wait for a while till network onboard is successful.

4. After the successful Onboard E2E Network, it can be managed through cnMaestro.

If PoP Node is running the Onboard E2E Controller then the PoP icon will be indicated with as shown below:

Onboard E2E Controller (Running Onboard) Onboarding with Serial Number

From homepage click Onboard icon in the left pane, to claim Onboard E2E devices.

1. Navigate to Onboard > 60GHz cnWave Network > click Claim Onboard E2E.

Claim Onboard E2E Network with Serial Number windows appears.

2. Enter Serial Number and click Claim Devices.